Dinolift DINO XT II 160, Operating Instructions Manual

Page: 57 / 73

57
FAULT REMEDY
7. Malfunctions of platform movements – only one of the movements can be operated
Lifting and lowering of the boom and the
extension of the telescope are not operational,
the red light is illuminated on the platform and
in the chassis control centre, and the buzzer is
audible.
The boom has been overloaded; retract the
telescope and retry the operation (automatic
reset).
18. Driving device does not operate, although the selector switch is in position LCB
Boom is not resting on the transport support. Drive the boom onto the support.
The emergency stop button of the cable-
operated remote control for the driving device
has been depressed.
Release the emergency stop button.
24. Wheel brakes overheat
Parking brake not completely released. Release the parking brake completely.
25. Ball-coupling is not locked
Inner parts of the ball-coupling dirty. Clean and lubricate.
Tow-ball of the towing vehicle too large.
Make sure that the towing ball of the towing
vehicle is the right size for the lift's tow hitch.
According to DIN74058, the diameter of the ball
must be max. 50 mm and min. 49.5 mm.
In all other fault conditions, the lift must be submitted to a qualified DINO service
provider.
To avoid malfunctions
• Follow the operating instructions
• Beware of dangerous situations, which can damage the lift
• Keep the lift clean and protect it against moisture