Dinolift DINO XT II 160, Operating Instructions Manual

Page: 25 / 73

25
3.3. SAFETY DEVICES
1. Supervision of transport position of the boom
The safety limit switch RK3 prevents the operation of the outriggers and the driving device
when the boom is not resting on the transport support. The switch is located on the tow-bar
at the transport support.
RK3
If the supervision of transport position is not functioning properly, the engine will stop. The
defect must be repaired before the operation can be resumed.
2. Supervision of supporting
The lift’s all support outriggers must be in the support position before the boom is lifted.
Make sure that the wheels are off the ground.
The safety limit switches RK11, RK12, RK13 and RK14 are located on the support
outriggers.
RK11, RK12, RK13, RK14
3. Overload control of the boom
The outreach limit switch RK4 and overload limit switch RK5 prevent the lift from being
overloaded by limiting the outreach of the lift to the side.
The limit switches are located under the cover at the top end of the lifting cylinder. During
operation, the cover must be intact and in place.
RK4, RK5