Dinolift DINO XT II 160, Operating Instructions Manual

Page: 64 / 73

64
Maintenance instructions • DINO 160XT II • 180XT II • 210XT II
8. ROUTINE MAINTENANCE DURING OPERATION
The maintenance operations, that are the responsibility of the operator, are described in this
chapter.
The more demanding maintenance operations that require special skills, special tools or
specific measurements and adjustment values are instructed in the separate Maintenance
Instructions. In such maintenance and repair cases, the operator shall contact an authorized
service provider, the distributor or the manufacturer.
Make sure that all the service and maintenance procedures of the lift are performed in time
and according to the given instructions.
DANGER
WARNING
CAUTION
NOTICE
Any such faults, observed during operation or periodic service, which affect the operational
safety of the unit, must be repaired before the lift is used next time.
Keep the lift clean. Clean the lift especially carefully before services and inspections.
Impurities may cause serious problems, for example, in the hydraulic system.
Use original spare parts and consumables. Consult the spare parts list for more detailed
information about the parts.
The first service after 20 hours of operation
• change the pressure filter element
• adjust the brakes according to the instructions (see point “Wheel brakes and bearings”)
• check the wheel bolts for tightness after about 100 km of driving
If the lift is operated under demanding conditions (in exceptionally humid
or dusty environment, corrosive climate, etc.) the intervals between the
oil changes and the other inspections shall be shortened to meet the
prevailing conditions in order to maintain the operational safety and
reliability of the lift.
The timely performance of the periodic servicing and the inspections
is absolutely mandatory, because neglecting them may impair the
operational safety of the lift.
The guarantee will not remain valid, if the servicing and the periodic
inspections are not performed.