Dinolift DINO 120T, Operating Instructions Manual

Page: 48 / 65

48
Operating instructions
•
DINO 120T
•
120TB
6. INSTRUCTIONS FOR FAULT-FINDING
120T START
FAULT REMEDY
1. The electric motor does not start from its start button although the selector switch 1
is in the position that enables operation from either the chassis or the platform control
centre
The emergency stop button has jammed in the
lower position.
Pull up the button and re-start the motor from the
start button.
Fuse F1 has blown. Replace the fuse (10A).
No mains supply (230 VAC) to the selector
switch.
Check the extension cords, possible distribution
boards and fuses.
Fault current safety switch has tripped. Reset the fault current safety switch.
2. No power supply to the lift, although the main switch is on and the selector switch
is in the position that enables operation from either the chassis or the platform control
centre
Power supply has not been activated.
Press the start button to activate the power
supply.
120TB START
FAULT REMEDY
1. The electric motor does not start when a movement is activated although the
selector switch 1 is in the position that enables operation from either the chassis or
the platform control centre
The main switch is disengaged. Switch on the main switch.
The emergency stop button has jammed in the
lower position.
Pull up the button and re-start the motor from the
start button.
The start switch has not been depressed at the
outrigger control unit.
Start the electric motor using the start switch.
Fuse F1 has blown. Replace the fuse (10A).
Power supply to the main centre is OK – reading
in the battery gauge is 0 %.
Batteries are flat –> recharge the batteries by
connecting the mains cable.
2. The electric motor does not start when either of the movements "boom up" or
"telescope out" is activated but starts normally when any of the other movements is
actuated
Low battery voltage, lifting movements are
impeded.
Recharge the batteries by connecting the mains
cable.