3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator
E-AF09_02_16.03_EN_U
64
13.5 SETTING AXLES SO THAT THESE ARE NOT TOTALISED
If the automatic weighing has been configured, it is possible to set a number of axles to not be totalised at the beginning
and/or at the end of the weighing cycle.
This is useful to weigh for example only the trailer, or when there are problems to acquire the weight of an axle that is not
really required.
It is possible to set the number of the axles in the setup environment (
<<SKIP B>>
and
<<SKIP E>>
step,
TECH.MAN.REF.
)
so that these are automatically activated upon each start-up, and/or change them in weighing phase with the following
function:
Through function
603
, combinable with the desired key (
<< F.KEYS >>
step,
TECH.MAN.REF.
), it’s possible to set the
number of axles to not be totalised at the beginning of the cycle. Set the value and press
ENTER
.
Through function
604
, combinable with the desired key (
<< F.KEYS >>
step,
TECH.MAN.REF.
), it’s possible to set the
number of axles to not be totalised at the end of the cycle. Set the value and press
ENTER
.
The set values in weighing phase are not saved in a permanent manner, but are substituted with each start-up from
the values set in the setup.
13.6 ADDITIONAL TARE FUNCTION
This function is useful if one wants to calculate the loaded/unloaded weight at the net of a tare added to the weight of the
vehicle taken into consideration.
By enabling the function in the
F.ModE >> totAL >> Add.tAr
step, it’s possible to have that, upon the output weigh, one is
asked to enter an additional tare, which will be subtracted from the loaded/unloaded weight value in the weigh.
After the pressing of the
F7
key and the selection of the “open” weigh in input, one enters the calculator environment (the
LCD display shows the message “ADDITIONAL TARE”).
Procedure:
With the numerical keyboard enter the first value then
Press
Fn
in order to consider this value as an additional tare
or
Press
F1
to add,
F2
to multiply,
F3
to subtract:
-
With the numeric keyboard enter the second value of the operation.
-
PRESS ENTER:
the result will be shown for a few seconds on the display and considered as additional tare.
The “CALCULATOR” print function will not be executed, but one proceeds with the printing of the output weigh, in which it is
possible to print also the additional tare.
The additional tare is automatically subtracted from the loaded or unloaded weight.