3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator
E-AF09_02_16.03_EN_U
37
13.2.2 AUTOMATIC STATIC AXLE WEIGHING
13.2.2.1 CONFIGURATION
-
Set parameter in the SETUP:
F.ModE >> totAL >> AXLE W
on
“STATIC”
.
-
If before was setted the
DYNAMIC
axles weighing, the indicator ask to set the filter of this weighing mode, press
FN/ENTER
to confirm.
-
For a correct functioning one should correctly set the weighing parameters in the
F.Mode >> total >> StA.CFG
menu of the Set-up environment or by a direct function 605, linked to a key.
(See the TECHNICAL MANUAL)
:
1.
”Min.Wei”
(minimum weigh of the axle);
2.
”Stab.tm”
(Stability interval);
3.
“tiME W”
(interval between cycles);
4.
”Skip B.”
(Beginning axles to skip);
5.
“Skip E.”
(Ending axles to skip);
6.
”Err.En”
(Axle acquisition error enable);
7.
”Tim.Out”
(Axle acquisition time out).
13.2.2.2 WEIGHING PROCEDURE
-
As soon as the indicator has completely turned on and enters in the weighing status, it waits for the first axle, the
indicator displays:
3590E
LED display
LCD display
CPWE
[In which:
XXXXXX
is the current weight on the scale]
-
Select, if requested, the customer / material / vehicle to be linked to the weigh.
-
Drive and stop the first axle of
the vehicle on the scale.
-
Wait a few instants, the axle will be acquired when:
1)
the weight is greater than the minimum weight of the set axle in
<< Min.Wei>>
step.
2)
the weight is stable.
-
After the weight of the first axle is acquired, the indicator emits a sound and displays for an instant the following
message:
3590E
LED display
LCD display
XXXXXX
CUS MAT VEH
WAITING AXLE 1
1
CUS MAT VEH
WAITING AXLE 1
AXLES: 1
TOT: YYYYY UM
SET FILTER ?