3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator
E-AF09_02_16.03_EN_U
63
13.4.2.2 ERROR ON THE STATIC AXLES WEIGHT ACQUISITION
3590E Visualizations
If the weight has passed the capacity of the scale.
If the maximum number of axles is reached.
The instrument is unable to compute the axle weight
The vehicle unload the platform, before that the axle
weighing acquisition is captured
Furthermore an output can be enabled until the next axle is acquired or the error is reset (see following function), in order to
inform the operator about the error. See “axle acquisition error” function in the section 15.6.
13.4.3 RESET OF THE ERROR AXLE IN THE DYNAMIC CYCLE
In case of error acquisition, normally the total is cancelled (the printout of the total will also not be made). If the error takes
place on one of the axles that is set to not be totalised (see section 13.5), this error will not be taken into consideration.
Through the function
602
combinable with the desired key
(<< F.KEYS >>
step,
TECH.MAN.REF.
), it’s possible to reset the
error so that the axle will not be taken into consideration: by pressing the linked key after the error, the total will be not
cancelled, the printout of the total will be made at the end of the procedure and if an output is set on the “axle acquisition
error” function (see section 15.6), it will be disabled.
13.4.4 MANAGING AN INPUT FOR THE CYCLE START/END
The beginning and the end of the weighing cycle can be defined, respectively, from the enabling and disabling of an external
input, instead of automatically done by time.
This can be useful for example if one needs to start the cycle through a photocell placed before the weighing area and stop it
with another photocell after, or with external buttons/remote controls.
In order to enable this type of management, one has to set
ZERO
seconds in the
F.Mode >> total >> StA.CFG >>
tiME W
step (interval between cycles), and
“Aut.cyc”
function in an input (in the set-up environment,
TECH.MAN.REF.
).
13.4.5 MANAGING THE OUTPUTS
It is possible to enable the functioning of the outputs in order to guide the driver during the axle weighing cycle, for example
enable an output:
-
when the cycle has been finished,
-
during the axle acquisition to inform that the weight is not yet acquired and therefore not yet stable,
-
when the axle is acquired to inform the driver to go on,
-
when an acquisition error has been occurred (see section 13.4.2).
The list of the available functions are described in detail at section
13.4.6 PAUSE AXLES CAPTURING
It is possible to enable the functioning to put in PAUSE the axle computation during the dynamic or static weighing cycle.
This is possible through the function
607
combinable with the desired key
(<< F.KEYS >>
step,
TECH.MAN.REF.
)
AXLE ACQUISITION
ERROR
AXLE ACQUISITION
ERROR
AXLE ACQUISITION
ERROR
AXLE ACQUISITION
ERROR