OPERATOR
’S MANUAL
with Maintenance Information
Operating Instructions
30
Note: Slope rating is subject to ground
conditions and adequate traction.
Press the drive speed select switch to the fast
drive speed mode.
To determine the slope grade
Measure the slope with a digital inclinometer
or use the following procedure.
You will need:
C
arpenter’s level
Straight piece of wood, at least 1 m long
tape measure
Lay the piece of wood on the slope
At the downhill end, lay the level on the top
edge of the piece of wood and lift the end until
the piece of wood is level.
While holding the piece of wood level,
measure the distance from the bottom of the
piece of wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply
by 100.
Example:
Run = 3.6 m
Rise = 0.3 m
0.3 m ÷ 3.6 m = 0.083 × 100 = 8.3%
If the slope exceeds the maximum slope or
side slope rating, the machine must be
winched or transported up or down the slope.
See Transport and Lifting section.
To Extend and Retract Platform
1 Lift the platform extension lock handle to
the horizontal position.
2 Push the platform extension lock handle to
extend the platform to the desired position.
Do not stand on the platform extension
while trying to extend it.
3 Lower the platform extension lock handle.
Battery Level Indicator
Full Low
Use the LED diagnostic readout to determine
the battery level.
Auxiliary Lowering
At the Ground Controls
Press and hold the lift function enable button.
Press and hold the platform down button.
At the Platform Controls
Press the lift function select button.
Push and hold the function enable switch.
Activate the control handle in the direction
indicated by the yellow arrow.
Operation from Ground with
Controller
Maintain safe distances between operator,
machine and fixed objects.
Be aware of the direction the machine will
travel when using the controller.
Outrigger Operation (if equipped)
1 Position the machine below the desired
work area.
2 Push and hold the outrigger auto level
button.
3 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine. A beep will sound when the
machine is level.
Summary of Contents for JCPT1523DC
Page 3: ......
Page 5: ......
Page 17: ...OPERATOR S MANUAL with Maintenance Information Decals 12 ...
Page 18: ...OPERATOR S MANUAL with Maintenance Information Decals 13 ...