DINGLI JCPT1523DC, Operators Manual With Maintenance Information

Page: 32 / 66

OPERATOR
’S MANUAL
with Maintenance Information
Function Tests
27
56 Push in the red Emergency Stop button
57 Pull out the red Emergency Stop button to
the on position.
58 Push and hold the function enable switch.
Activate the control handle in the direction
indicated by the yellow arrow.
⊙
Result: The platform should lower.
Test Outrigger Auxiliary Retract
59 Lower the platform to the lowest position.
60 Operator comes back to the ground, and
operates the machine on the ground
control.
61 Press and hold the lift function enable
button. Press and hold the platform down
button. Press and hold the overload
indicator button
⊙
Result: The outrigger should retract.
Test the Oscillate System
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
Test the Oscillate System (stowed position)
62 Drive the left steer tire up onto a 10 cm
high ramp.
⊙
Result: All four tires should maintain firm
contact with the ground.
63 Drive the right steer tire up onto a 10 cm
high ramp.
⊙
Result: All four tires should maintain firm
contact with the ground.
Note: Verify that there are no fault codes
shown on ground control display.
Test the Oscillate System (elevated
position)
64 Press the lift function select button. Raise
the platform approximately 3.5 m from the
ground.
65 Drive the left steer tire into a 10 cm deep
hole.
⊙
Result: All four tires should maintain firm
contact with the ground.
66 Drive the right steer tire into a 10 cm deep
hole.
⊙
Result: All four tires should maintain firm
contact with the ground.
Note: Verify that there are no fault codes
shown on ground control display.