DINGLI JCPT1523DC, Operators Manual With Maintenance Information

Page: 49 / 66

OPERATOR
’S MANUAL
with Maintenance Information
Maintenance
44
B-4
Inspect the Tires and Wheels
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Maintaining the tires and wheels in good
condition is essential to safe operation and
good performance. Tire and/or wheel failure
could result in a machine tip-over. Component
damage may also result if problems are not
discovered and repaired in a timely fashion.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
3 Check each lug nut for proper torque.
lug nut torque, dry 169.5Nm
lug nut torque, lubricated 127.4Nm
B-5
Check the Oil Level in the Drive Hubs
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Failure to maintain proper drive hub oil levels
may cause the machine to perform poorly and
continued use may cause component
damage.
1 Drive the machine to rotate the hub until
the plugs are located one on top and the
other at 90 degrees.
a drive hub plugs
2 Remove the plug located at 90 degrees
and check the oil level.
⊙
Result: The oil level should be even with the
bottom of the side plug hole.
3 If necessary, remove the top plug and add
oil until the oil level is even with the bottom
of the side plug hole.
4 Apply pipe thread sealant to the plug(s),
and then install the plug(s) in the drive
hub.
5 Repeat this procedure for each drive hub.
Original oil specifications
：
80W-90