DINGLI JCPT1523DC, Operators Manual With Maintenance Information

Page: 52 / 66

OPERATOR
’S MANUAL
with Maintenance Information
Maintenance
47
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
8 Replace the brakes and repeat this
procedure beginning with step 1.
Braking distance, maximum
High range on paved surface
＜
150cm
B-10
Test the Drive Speed - Stowed
Position
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Proper drive function movement is essential to
safe machine operation. The drive function
should respond quickly and smoothly to
operator control. Drive performance should
also be free of hesitation, jerking and unusual
noise over the entire proportionally control led
speed range.
1 Create start and finish lines by marking
two lines on the ground 12.2m apart.
2 Turn the key switch to platform controls
3 Pull out the platform and ground red
Emergency Stop button to the on position.
4 Lower the platform to the stowed position.
5 Choose a point on the machine; i.e.,
contact patch of a tire, as a visual
reference for use when crossing the start
and finish lines.
6 Bring the machine to maximum drive
speed before reaching the start line. Begin
timing when your reference point on the
machine crosses the start line.
7 Continue at full speed and note the time
when the machine reference point passes
over the finish line. The time is less than
7.2sec.