Appendix
DigiTrak
®
F5
®
SST
®
Operator’s Manual
61
General SST Transmitter Care Instructions
Do not pull on the transmitter’s cable. A cable transmitter extraction/insertion tool, which is essentially a
threaded metal rod, is provided with the transmitter and is available through any authorized DigiTrak
dealer. It is used for inserting and extracting the cable transmitter into or out of the housing. Two threaded
holes (1/4”-20 thread) are provided at the back of the cable transmitter for threading the extraction tool.
If the cable wire becomes exposed at the base of the transmitter, the cable should be trimmed and
reinstalled or replaced.
Instructions and parts for replacing the cable are provided in the Replaceable Wire Kit (DCKIT) sent with
the cable system and available through any authorized DigiTrak dealer.
The SST transmitter must be kept at least 5 ft (1.5 m) away from all magnets including the remote display,
which has a magnetic mount that will damage the transmitter. A protective magnetic shield is provided
with the SST transmitter and is available through any authorized DigiTrak dealer. The magnetic shield
should be placed on the end of the SST transmitter at all times when the transmitter is not in use.
Placing tape around the fiberglass tube of the transmitter, if space allows, will keep the fiberglass
protected from most corrosive environmental wear.
Send in the Product Registration Card for the 90-day Limited Warranty.
General Cable Box Care Instructions
Do not disassemble. The cable box contains no user-serviceable parts.
Clean exterior with a damp cloth.
Do not submerge.
Do not pressure wash.
Ensure all ports remain clean and clear of debris. Pressurized air or a soft brush may be used to remove
debris from the cable ports.
A wire brush may be used to clean the power post.
Send in the Product Registration Card for the 1-year Limited Warranty.
