3.0 Plug N’ Play with your DT400
1. Plug the DT400 series throttle into any functioning Digitrax
LocoNet System or other LocoNet compatible system
and you are
ready to go! You can use any LocoNet jack on your system.
2. First, you will see the DT400 version number screen:
This screen shows the DT400’s
software version number. It is
displayed for a few seconds
each time you power on the
DT400.
3. Next you will see the power indicator screen:
This screen indicates the
power available to the throttle.
When you are plugged in to
LocoNet, this value will be
between 9 & 15 volts. when
you insert a battery or unplug from LocoNet, the value displayed
will be the battery power available. When this number is less than
6.2 volts it’s time to consider replacing or recharging your battery.
See section 22 for more information about using batteries with your
DT400.
4. Then you will hear the throttle beep and you will see a screen
similar to the following.
If your throttle is a DT400R or if there is
a UR90 or UR91 connected to your system see section 21 for addi-
tional information about radio &/or infrared operation of your throt-
tles.
This screen displays current
addresses selected on the L & R
throttles along with their current
speed and direction. The func-
tions that are turned ON for the
active throttle (the one with the
blinking smoke icon) are dis-
played across the top of the dis-
play.
5. To begin operations, simply turn or single click either throttle
knob or press any key
to initiate any throttle task.
7
