4.3.4 Mode Indicator
The mode indicator, located at the bottom center of the LCD, shows the
DT400’s current mode of operations.
Table I: DT400 Mode Indicator Display
Display Mode
Used For
Fn
Function
Normal locomotive operation
functions available on keypad
Lo
Loco Selection
Locomotive Address Selection
Mode
Mu
MU
Multiple unit (consist) operation set
up and break up
Sw
Switch
Accessory decoder control
(turnouts, etc.) or option switch
control
Pw
Power
Turn track power on and off
S
E
Status Edit
Change locomotive speed steps to
14, 28, or 128 as needed
Pg
Programming
Paged-Digitrax preferred method
Ph
Programming
Physical Register
Pd
Programming
Direct
Po
Programming
Operations Mode (Ops Mode)
programming on the mainline.
R
E
Recall
Recall one of the last 4, 8, or 16
locomotive addresses used
Fd
Find
Find command issued for active
loco, results displayed in text area.
Ec
Edit fast clock
Edit the time shown on the fast
clock
E
F
Edit fast clock
rate
Edit the fast clock rate
E
A
Edit alarm
Edit the alarm time set for the
throttle
Er
Edit routes
Edit routes-shows when your
system is running with a DCS100
with routes enabled
E
1
Change
LocoNet ID
Change LocoNet ID for Infrared or
Radio Operation
E
?
Other edit
modes
Show when your system is running
with a LocoNet component that is
enabled for additional functionality
such as signaling.
19
