17.5 Edit Routes
To go to the Edit Routes (Er) mode you must pass through the clock editor:
1. Start in Fn mode. Press the EDIT Key
to enter Edit Mode.
Press the EDIT Key again to enter Ec (Edit Clock) mode.
Press the EDIT Key again to enter E
F
(Edit Fast Rate) mode.
Press the EDIT Key again to enter E
A
(Edit Alarm) mode.
Press the EDIT Key again to enter Er (Edit Routes) mode.
The DT400’s display will show the following screen when you enter the
Edit Routes mode.
This display shows Er (Edit Routes) in the Mode Indicator area on the
bottom row to let you know you are in Edit Routes mode.
The right side of the bottom row shows which route you are working
with. This can be any number from 01 through 32.
The left side of the bottom row of the display shows which entry within
the route you are working with. The En (entry) number can be any
number from 01 through 08.
En01 is the TOP or controlling turnout address. The position, c or t, that
you set for this turnout address is the one that will operate the route.
The text area shows “Sw empty” to let you know that nothing has been
entered for Entry 01, Route 01.
2. Use the R Throttle knob to dial up the Route number you want to
work with. The bottom right display will show the route number.
The DT400 will allow you to dial up above route 32 but please DO
NOT USE route numbers outside the range of 01-32.
3. Use the L Throttle knob to dial up the Entry number within the cho-
sen route that you wish to work with. The bottom left display will
show the entry number.
E D I T
61
