5. Find will remain active until you press the FIND Key again to disable
find mode.
19.0 Shut Down and Resume Procedures
Some users prefer to “dispatch” or release all addresses active in their system
before shutting down. This can prevent unexpected results when you power up
the layout again. This procedure is covered in detail in Section 12.1.
1. Turn track power off: Press the PWR Key
followed by the N -
Key
, the Track Power Indicator on the DT400 and the Track
Status Indicator on your command station will go off.
2. Move the command station’s “MODE” switch to the “SLEEP” posi-
tion .
3. Turn off the power supply to the system.
N
PWR
This example shows a DT400 in FIND
mode for address 1652 selected on the
R Throttle. The system sees address 1652
in Zone 0010. When address 1652 moves
to another Zone, the display will automatically
update to show the new Zone location.
This example shows a DT400 in FIND
mode for address 03 selected on the
L Throttle. The system is not able to
find address 03 so there is no display
after the <Zn. Either the loco or rolling stock
with address 03 is not present on the layout
or it does not have a transponder or it is
located in a zone that does not have a
transponder receiver.
64
