format, the depth of the recall stack, the throttle ID#, and which radio frequen-
cy the throttle will use.
To make these changes, consult the following tables to determine which option
values to set up in Option #1, Option #2, Option #3, Option #4, Option #F &
Option #6.
To change DT400 Option Settings
1. Consult the tables below to determine which settings you want to
make for each of the 6 available option tables.
2. Press the OPTN t Key
and the display will show:
3. The right side of the display will show the current value for OP#1.
The default setting for OP#1 is x01. Notice that these values are
entered in hex format. The “x” in front of the value lets you know
to expect to use hex numbers. Pressing the throttle keys will not
change to decimal values in this case.
4. Use the R or L throttle knob to change the setting for OP#1. Set the
option value selected from the table below for OP#1.
5. Press the ENTER Key
to set OP#1 to the value selected and
advance to OP#2.
6. Dial in the value selected from the table below for OP#2 and Press
the ENTER Key
to set OP#2 to the value selected and advance
to OP#3.
7. Dial in the value selected from the table below for OP#3 and Press
the ENTER Key
to set OP#3 to the value selected and advance
to OP#4.
8. You should not need to change the values for OP#4, OP#F or OP#6
so press the ENTER Key
three more times to step though these
options.
E N T E R
E N T E R
E N T E R
E N T E R
OPTN
OPTN
tt
74
