Digital Projection
Titan Quad, & Titan 800 Series
POSITIONING THE SCREEN AND PROJECTOR
Installation and Quick-Start Guide
Inst 4
Rev F November 2012
Positioning The Screen And Projector
•
Install the screen, ensuring that it is in the best position for viewing by your audience.
•
Position the projector, ensuring that it is at a suitable distance from the screen for the image to fill the screen.
Chassis adjustment
•
If the projector is to be operated from a flat surface such as a projector table, then adjustment of projector level should be made by turning
the four feet under the chassis. Set the adjustable feet so that the projector is level, and perpendicular to the screen.
Fitting and adjusting the optional Rigging Frame
•
Remove the four adjustable feet.
•
Secure the rigging frame to the projector, as shown below, making sure that the cable
attachments are at the top. Three screws secure each of the adjuster brackets to a corner
handle.
•
To adjust the pitch, turn either the front pair or the rear pair of vertical adjusters, taking
care to turn both adjusters by the same amount.
•
To adjust the roll, turn either the left pair or the right pair of vertical adjusters, taking care
to turn both adjusters by the same amount.
•
To adjust the yaw, turn the single horizontal adjuster at the front.
Fixing
screws
Yaw
Horizontal
adjuster
Vertical
adjusters
Frame
couplings
Pitch
Roll
Notes
Always allow the projector
to cool for 5 minutes before
disconnecting the power or
moving the projector.
Ensure that there is at least
30cm (12in) of space between the
ventilation outlets and any wall,
and 10cm (4in) on all other sides.
Do not stack more than 3
projectors.
Do not place heavy objects on top
of the projector chassis. Only the
chassis corners and the rigging
frame are capable of withstanding
the weight of another projector.
Do not place the projector with its
front panel down on a surface, as
this may damage the lens or the
lens release lever.
Backup safety chains or wires
should always be used with
ceiling mount installations.
Do not tilt the projector more
than ±12° in either direction, in
desktop or ceiling mode, when in
use, as this may cause serious
lamp failure, damage the lamp
module and cause extra cost on
replacement.
±12°
±12°
±12°
±12°
Ceiling
Desktop
