Page 5.2
Rev D July 2014
5. Maintenance
Digital Projection
HIGHlite Cine 260, 1080p 330
User Manual
Changing the lamp module
•
Turn the power OFF and allow the lamp to cool for 5 minutes.
•
Unscrew the captive finger screw securing the lamp door, and remove the door.
•
Unscrew the two cross-head screws securing the lamp module to the projector
•
Lift the wire handle up and use it to pull out the lamp module.
•
Fit a new lamp module, pushing it firmly into place.
•
Tighten the two cross-head screws.
•
Locate the two lugs at the bottom of the lamp door into the slots, and re-fit the
door. Tighten the finger screw.
Notes
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
- moving the projector
- changing the lamp
There are no user-serviceable
parts inside the lamp module.
The whole module should be
replaced.
Only lamps supplied by
Digital Projection and
intended for this projector
should be used. Fitting any
other lamp could damage
both projector and lamp, and
will invalidate the warranty.
At the end of life, the lamp
will not strike, and the
Issue
indicator on the control panel
will flash red. (Typical lamp life
is 2000 hours)
Do not use the lamp for more
than 2000 hours, as this may
cause serious lamp failure,
damage the lamp module
and cause extra cost on
replacement.
Take care not to touch the
glass surface of the lamp
module. If you do accidentally
touch the glass, it should be
cleaned before use.
HID lamps produce high
intensity light. Do not look
directly at the light coming
from the lamp housing or the
lens.
Opening the lamp door will
switch the projector OFF. The
projector cannot be operated
until the door is fully closed.
