DG-LB1054UV User Manual
74
3.2.3.1.2 IPSec Configuration
1.
IPSec:
You could trigger the function of IPSec VPN if you check
“Enable”
.
2.
NetBIOS over IPSec:
If you would like two Intranets behind two VPN gateways to
receive the NetBIOS packets from Network Neighborhood, you have to check
“Enable”
.
3.
NAT Traversal:
Some NAT routers will block IPSec packets if they don’t support IPSec
pass through. If your VPN gateway connects to this kind of NAT router which doesn’t
support IPSec pass through, you need to activate this option in your VPN gateway.
4.
Max. Concurrent IPSecTunnels:
The device supports up to 32 IPSec tunnels, but you
can specify it with the number of maximum current activated IPSec tunnels that is smaller
or equal to 32.
You can add new, edit or delete some IPSec tunnels in Tunnel List & Status as follows.
3.2.3.1.3 Tunnel List & Status
1.
Add:
You can add one new IPSec tunnel with Site to Site scenario by clicking the “Add”
button.
2.
Delete:
Delete selected tunnels by checking the “Select” box at the end of each tunnel list
and then clicking the “Delete” button.
3.
Tunnel:
Check the “Enable” box to activate the IPSec tunnel.
4.
Edit:
You can edit one tunnel configuration by clicking the “Edit” button at the end of
each tunnel list.
Note: Tunnel ID1 is only for Dynamic VPN.
