Digi TransPort WR11, User Manual

Page: 837 / 866

Device administration Manage files
Digi TransPort WR Routers User Guide 826
▪
You can use these events to debug the correct matching string to match on when trying to
configure these parameters.
▪
If both lists are left blank, all drivers are enabled and no extra events appear in the event log.
Universal config.da0 using tags
The config.da0 contains a list of commands, one per line that are parsed at boot. The commands in
this file differ, depending on the model of the router, the firmware in use and the hardware options
installed.
You can create a single universal configuration file using tags, defining sections that only relate to a
specific hardware type or firmware version.
The tag values you can use are:
▪
The base model, for example: DR6410
▪
The complete model, for example: DR6410-H0A
▪
The platform build string, for example: 8W
▪
The type of DSL, for example: DSL2 , 2+
▪
The type of WWAN module detected, for example: E (Edge), C (CDMA)
▪
The complete WWAN module string, for example: MOTO_G24 SIEMENS_GPRS , SIEMENS_MC75 ,
NOVATEL_3G , SIERRA_3G , OPTION_3G , NOVATEL_CDMA , CMOTECH_CDMA , SIERRA_CDMA
▪
PSTN or ISDN module, for example: PSTN , ISDN
Enclose the tags within angle brackets. Open AND close the configuration sections with the relevant
tag. For example, to open: <DR6410>
To close: </DR6410>
Note use of the / in the closing tag.
To view a list of defined tags on a router, use the CLI command tags . Here is example output of the
tags command:
Router>tags
tags defined:..
TransPort
DR64
dr6410
8W
OPTION_3G
ISDN
DSL
61690
OK