Digi TransPort WR11, User Manual

Page: 158 / 866

Configure network interfaces Configure Ethernet interfaces
Digi TransPort WR Routers User Guide 158
Ethernet QoS Parameters
The parameters on this page control the Quality of Service management facility. Each Ethernet
interface has an associated QoS instance, where ETH 0 maps to QoS 5, ETH 1 maps to QoS 6 and so
on. These QoS instances include ten QoS queues into which packets may be placed when using QoS.
Each of these queues must be assigned a queue profile from the twelve available.
Enable QoS on this interface
When enabled, displays the following QoS configuration parameters:-
Link speed n Kbps
Set this setting to the maximum data rate that this PPP link is capable of sustaining. The router
uses this setting when calculating whether or not the data rate from a queue can exceed its
minimum Kbps setting, as determined by the profile assigned to it and send at a higher rate (up
to the maximum Kbps setting).
Queue n
Below this column heading is a list of ten queue instances. Each instance is associated with the
profile and priority on the same row.
Profile n
This column contains the profile to be associated with the queue. There are twelve available,
0-11 , selected from the drop-down list boxes.
Priority
This column contains drop-down menu boxes for assigning a priority to the selected queue. The
priorities available are Very High , High , Medium , Low , and Very Low .