Digi TransPort WR11, User Manual

Page: 388 / 866

Configure IP routing and forwarding OSPF parameters
Digi TransPort WR Routers User Guide 388
Restart OSPF after configuration file is saved
When enabled, restarts the OSPF functions once the edited configuration file has been saved.
Restart OSPF if a fatal error occurs
When enabled, restarts OSPF functioning after a delay of 5 seconds if a fatal error occurs.
OSPF Tracing
In common with some of the other functionality of the router, OSPF supports some debug
functionality. The amount of information in the debug traces is controlled from this drop-down
list. The available levels are Off , Low , Med , and High . Selecting Off disables debug tracing.
Ignore MTU indications
All OSPF routers must have the same Maximum Transmitted Unit (MTU) and this value is
advertised in the OSPF packets. When checked, the router ignores received packets that have a
MTU that differs from that of the router itself.
Use Interface IPsec source IP
When enabled, OSPF functions use the source IP address of the interface specified in
Configuration > Network > Interfaces > Advanced > PPP n: Use interface x,y for the source
IP address of IPsec packets on the interface being used . When unchecked, OSPF uses the
source IP address of the interface in use for its source address.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ospf 0 Enable on,off Enable OSPF
ospf 0 conffile OSPF Configuration Filename
ospf 0 new_cfg_rest on,off Restart OSPF after a configuration file is
saved
ospf 0 fatal_rest on,off Restart OSPF if a fatal error occurs
ospf 0 debug 0-3
0=Off
1=Low
2=Med
3=High OSPF Tracing
ospf 0 ignore_mtu on,off Ignore MTU indications
ospf 0 useipsecent on,off Use Interface IPsec source IP