Dickey-John seed manager, Operator'S Manual

Page: 47 / 71

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
OPERATION / 45
OPERATION
OPERATE MODE
Performance of the following Operate Mode functions assumes the console
has been properly installed and setup as detailed in the INSTALLATION
and SETUP MODE sections respectively. (
Figure 51 ) lists all Operate
Mode functions and shows which are available in Speed Area Mode
(defined later in this section). This list includes all the function names on
the three (3) Operate Mode switches, plus the Run Hours function which is
performed automatically.
Figure 51
RUN HOURS
This is defined as the total number of accumulated hours, in 0.1 hour
increments, the console has been powered. Run Hours are not
accumulated during an ALL ROWS FAILED condition or if a lift switch is
installed and the implement is in the up position. The Run Hours total is
displayed for five (5) seconds immediately following the power up
sequence. The SETUP switch or any of the three Operate Mode switches
can be pressed during the display of the Run Hours to advance immediately
to the desired function. Otherwise the Population function is automatically
selected. To zero the accumulated Run Hours, press the START STOP
RESET switch for one (1) second while Run Hours are displayed.
(
Figure 52 ) shows Run Hours of 47.5.
Figure 52
Run Hours Display
Operate Mode Function Name Available in Speed Area Mode
Run Hours
Yes
Population
No
Seed Spacing
No
Ground Speed
Yes
Fan Speed
Yes
Shaft Speed
Yes
Pressure
Yes
Area Accumulator
Yes
Seed Count
No
Distance Accumulator
Yes