DFI 586ITBD, User Manual

Page: 30 / 89

586ITBD System Board User’s Manual
2
30
To install an upgrade processor, do the following:
1. Make sure the handle on the side of the ZIF socket is up. To
raise the handle, push it down, slightly pull it out to the side,
then raise it as far as it will go. It may be necessary to initially
apply a small amount of sideways force to free the handle from
its retaining “tab”. Once clear of the “tab”, the handle will open
relatively easily. The top plate will slide back. Do not use screw-
drivers or other tools to open the socket, or you may damage
the system or socket.
Lifting the Handle
2. Once the lever is completely up, remove the old processor
carefully by lifting it straight out of the socket. You are now
ready to insert the new processor.
Handle
Pin 1