|
Auto-configuration
55
|
devolo dLAN 200 DSpro Manual
|
쑗
36896 = 0x9020 MV TDREPEATER
쑗
36912 = 0x9030 LV MASTER
쑗
36928 = 0x9040 LV TDREPEATER
쑗
36944 = 0x9050 LV CPE
쎲
STP_PORT.i = [EXTA|EXTB|PLC]
The following two parameters will be configured depending on this parame-
ter. For instance if STP_PORT.2 = EXTA, then STP_PORT_PRIO.2 = xx and
STP_PORT_COST.2 = xxx are referred to EXTA. Only EXTA, EXTB and PLC
can be configured. If PLC is selected, the priority and cost will be changed
for ALL PLC ports.
쎲
STP_PORT_PRIO.i = [0-255]
Priority of the port (necessary if costs are equal). Default value (for ETHA,
ETHB and PLC): 80.
쎲
STP_PORT_COST.i = [0-200000000]
Cost of the port is represented by 4 bytes. It is recommended not to use a
number greaterthan 200000000 so as not to exceed the accumulated maxi-
mum of 4294967296. Default values:
쑗
ETHA = 2000000
쑗
ETHB = 2000000
쑗
PLC = 4000000
쎲
STP_HELLO_TIME = [10-100]
Hello time expressed in decisecs. Default value: 20 decisecs.
쎲
STP_MAX_AGE = [60-400]
Max. age time expressed in decisecs. Default value: 200 decisecs.
쎲
STP_FORWARD_DELAY = [40-300]
Forward delay time expressed in decisecs. Default value: 150 decisecs.
NOTE: Although values are configured in tenths of a second, the bridge has
a time resolution of 1 second. Non integer values will be correctly codified
but changes will take effect in the next integer second. For example: if a
hello time of 3.1 seconds is set, hellos are sent every 4 seconds.
쎲
STP_FRONTIER = [NONE|EXTA|EXTB]
Drops all STP packets in an external port. Default value: NONE.
쎲
STP_MODE = [STP|RSTP]
STP protocol version: Common (802.1d) or Rapid (802.1w). Default value:
RSTP.
Summary of Contents for dLAN 200 DSpro
Page 1: ...dLAN 200 DSpro Manual...
