Auto-configuration
|
|
devolo dLAN 200 DSpro Manual
|
42
쑗
If NONE is selected, all of the users are accepted.
Default value: NONE.
쎲
GENERAL_STP = [yes|no]
Enables/disables the Spanning Tree Protocol in the node. Default value: yes.
쎲
GENERAL_COMMON_STP_EXTA = [yes|no]
Enables/disables the Common STP feature in Ethernet interface A (EXTA). It
only makes sense to use this parameter if VLANs are enabled. If it is set to
“yes”, STP pakkets will be released and accepted through EXTA without
VLAN tags (even if VLANs are enabled). If its value is “no”, STP packets will
be released with the management VLAN tag (if VLANs are active).
WARNING
: With this parameter enabled, all packets without VLAN tags will
be accepted through EXTA.
쎲
GENERAL_COMMON_STP_EXTB = [yes|no]
Same as GENERAL_COMMON_STP_EXTA but for EXTB.
쎲
GENERAL_IP_ADDRESS = <ddd.ddd.ddd.ddd>
IP address of the dLAN 200 DSpro adapter (for the next boot if DHCP is
disabled).
쎲
GENERAL_IP_NETMASK = <ddd.ddd.ddd.ddd>
IP netmask of the dLAN 200 DSpro adapter (for the next boot if DHCP is
disabled).
쎲
GENERAL_IP_GATEWAY = <ddd.ddd.ddd.ddd>
IP default gateway of the dLAN 200 DSpro adapter (for the next boot if
DHCP is disabled).
쎲
GENERAL_IP_USE_DHCP = [yes|no]
The node does/does not use DHCP for the next boot if NVRAM mode is used.
쎲
GENERAL_SIGNAL_MODE = [1-14]
In HE: Signal mode for transmitting. Mode 9 does not exist; now the same
configuration corresponds to a mode 5 submode 4.
쎲
GENERAL_SIGNAL_MODE_LIST.x = [1-14]
In CPE and TDREPEATER: The list represents the allowed signal modes used
by the Search Link to find a master. (x=1…14). CPE and TDEREPEATER
nodes that do not implement Search Link can use this parameter, but only
the last mode in the autoconfiguration file will be taken into consideration.
Default value: all modes allowed.
Summary of Contents for dLAN 200 DSpro
Page 1: ...dLAN 200 DSpro Manual...
