|
Writing an Autoconfiguration File
17
|
devolo dLAN 200 DSpro Manual
|
For a basic network with one master and several slaves only two configuration
files are needed. The simplest configuration file for a master is shown in Figure
7. Figure 8 presents the simplest configuration file for a slave.
Figure 7: Simplest
Master Configuration
Figure 8: Simplest
Slave Configuration
With these two files and some configuration to the DHCP/TFTP server, a simple
one-level network can be built.
#File : master.conf
#General parameters
GENERAL_USE_AUTOCONF = yes
GENERAL_MAC_MODE = ACCESS
#Configure the node as Master (HE)
GENERAL_TYPE = HE
GENERAL_FW_TYPE = LV
GENERAL_AUTHENTICATION = none
GENERAL_STP = yes
# Signal parameters
GENERAL_SIGNAL_MODE = 6
AGC_TX_GAIN = 0
# QoS Configuration
QOS_ENABLE = no
# Vlan configuration
VLAN_ENABLE = no
#File : slave.conf
#General parameters
GENERAL_USE_AUTOCONF = yes
GENERAL_MAC_MODE = ACCESS
#Configure the node as Slave (CPE)
GENERAL_TYPE = CPE
GENERAL_FW_TYPE = LV
GENERAL_AUTHENTICATION = none
GENERAL_STP = yes
# Signal parameters
AGC_TX_GAIN = 0
# QoS Configuration
QOS_ENABLE = no
# Vlan configuration
VLAN_ENABLE = no
Summary of Contents for dLAN 200 DSpro
Page 1: ...dLAN 200 DSpro Manual...
