|
Auto-configuration
73
|
devolo dLAN 200 DSpro Manual
|
쎲
Once the dLAN 200 DSpro adapter has an IP, log in to the console and exe-
cute the commands below (
N
OTE
:
Due to VLAN switching, the console may
seem to hang; if this occurs, log out from the console and log in again):
쑗
ac stop:
Stops the autoconfiguration process (and also IFCP) and disab-
les the VLANs. It is advisable to execute this command first to work com-
fortably with the dLAN 200 DSpro adapter. This command does not
write anything in the NVRAM, so it only takes effect when the dLAN 200
DSpro adapter is reset;
쑗
ac ifcpmode set 0:
Disables IFCP in the next boot, writing in the
NVRAM. (
“
ac ifcpmode set 1
”
enables IFCP in the next boot, writing in
the NVRAM);
쑗
ac ifcpmode get:
Checks the IFCP state for the next boot, reading the
NVRAM.
N
OTE
: DHCP should be used (if possible) to disable IFCP.
12.14.1.4 Configuration Show Command
To show the running or stored NVRAM configuration, use the
csh
command:
csh {RUN|NVRAM|?} [params_set]
To show help, execute the
csh ?
command.
Usage: csh {run|nvram|?} [params_set]
run : Shows the running configuration
nvram: Shows the configuration stored in NVRAM
? : Shows this help
params_set:
general: General configuration parameters set
radius : Radius parameters set
cos : Class of Service parameters set
qos : Quality of Service parameters set
profile: Profile parameters set
transt : Translation table paramters set vlan :
VLAN parameters set
ovlan : OVLAN parameters set accessp: Access Pro-
tocol parameters set
Summary of Contents for dLAN 200 DSpro
Page 1: ...dLAN 200 DSpro Manual...
