|
Useful Console Commands
25
|
devolo dLAN 200 DSpro Manual
|
If you want to check the current network configuration, type "/net ip". The dLAN
200 DSpro adapter will report its MAC address, its IP, subnet mask and gateway.
11.7
Changing the Frequency Band
In the master dLAN 200 DSpro adapter, you can set the band in which the dLAN
200 DSpro adapter will transmit. All slaves linking to this master will use the
same band. The frequency band is called "PLC mode" and its value is between
1 and 13.
You do not need to specify the PLC mode in the slave dLAN 200 DSpro adapter
because it will automatically search through all possible modes until it finds a
master.
To change the PLC mode, you must type, for example, "/s m 6" to switch to mode
6.
To change the PLC mode and make it permanent, type "/s m w 6". This will store
the mode in the flash memory and the next time the dLAN 200 DSpro adapter
boots it will start using this mode.
11.8
Changing the MAC Mode
The dLAN 200 DSpro adapter can take three different roles in the MAC protocol:
master, slave, or time division repeater (TDR).
쎲
To set the dLAN 200 DSpro adapter as a master, type "/m c n m" (stands for
"mac change node master").
쎲
To set the dLAN 200 DSpro adapter as a slave, type "/m c n s".
쎲
To set the dLAN 200 DSpro adapter as a repeater, type "/m c n r".
If you are running in static configuration mode, these changes are permanent.
The dLAN 200 DSpro adapter will start in the selected mode the next time it
boots.
Summary of Contents for dLAN 200 DSpro
Page 1: ...dLAN 200 DSpro Manual...
