Original User Guide | Pedelec Integrale 0.5 Version 1
EN-63
8.3
Charger
Display Description
Cause
Remedy
The red
LED flashes
continuously.
There is a
charging fault.
Unplug the charger from the
mains immediately. If the
problem reoccurs, a new
battery charger is required.
9.
Torque settings
DANGER
Only use appropriate tools to tighten screws and bolts. Observe
the specified torque setting. The component manufacturer's torque
settings take precedence (where available). Failure to comply can
result in screws/bolts becoming loose, tearing away or fracturing. If
that happens while you are riding the bike, components may come
off and you could have a severe crash. If screws are overtightened,
components can also be damaged. Tighten all screws and bolts
that are relevant for safety with a torque wrench. This indicates the
corresponding torque in newton metres (Nm).
If no values are shown on the component or component manuals, use the
torque settings from the following table.
User guides, service book and declarations of conformity are available
for download in PDF format at:
www.derby-cycle.com/de/downloads/downloads.html
Find a cycle dealer near you:
www.kalkhoff-bikes.com/de/service/dealer-search.html
Screw fixing
Thread
Tightening torque (Nm)
Foot pedal
M8
35 – 40
Pedal
9/16
40
Front wheel threaded axle
General
25 – 30
Rear wheel through-axle
General
12 – 14
Seat clamping bolt
M6
12
Sliding drop-outs
M10
16
Shimano disc brake caliper
M6
6 – 8
Gear lever clamp
M5
5
Luggage rack
M5 / M6
M5: 5 – 6 / M6: 8 – 10
Front light
M5
3
Handle bars
M4 / M5
M4: 3 / M5: 5
BLOKS Twist-Lock + Remote
1