EN-58
Original User Guide | Pedelec Integrale 0.5 Version 1
7.4
Tips
7.4.1 Cleaning
DANGER
Always unplug the charger from the mains before cleaning and
especially before wiping it, otherwise you could get an electric shock
if you touch the contacts.
PLEASE NOTE
Do not immerse the charger in water. Damage may still result even
though the components are sealed.
Do not use any alcohol-, solvent-based or abrasive cleaners for
cleaning. No coarse sponges or brushes may be used either. They leave
scratches and cause the surface to become matt. Clean the charger
with a soft damp cloth.
1. Remove the charging cable from the battery charging socket.
2. Unplug the charger from the mains socket.
3. Clean the housing with a slightly damp, soft cloth.
4. If the contacts are dirty, clean them with a soft dry cloth.
7.4.2 Storage
1. Store the battery charger in a dry, not excessively warm room. The
charger should not be exposed to a direct sun.
The recommended storage temperature range is from 18 to 23 °C.
If the battery now stays on the charger, the charger
regularly checks whether the battery is still fully charged.
The LED charger starts to flash again. After checking that the
battery is full, the charger switches back to “steady” mode.
5. Remove the power cable from the socket after completing the charging
process.
6. Remove the charging cable from the battery charging socket.
7. Fold down the protective battery cap.
7.3.1.1 Battery display during charging
Display
Description
Battery charge level
5 LEDs light up and no LED flashes
80 % – 100 %
4 LEDs light up and the 5th LED flashes
60 % – 80 %
3 LEDs light up and the 4th and 5th LEDs
flash in ascending order
40 % – 60 %
2 LEDs light up and the 3rd-5th LEDs flash
in ascending order
20 % – 40 %
1 LED lights up and the 2nd-5th LEDs flash
in ascending order
5 % – 20 %
0 LEDs light up and the 1st-5th LEDs flash
in ascending order
0 % – 5 %
