Original User Guide | Pedelec Integrale 0.5 Version 1
EN-25
DANGER
It should be so hard to close the quick-release skewer that you need
to use the balls of your hands (120 N: corresponds to a weight force of
12 kg). You should have the mark of the lever imprinted on your hand.
Otherwise, it could open when you are cycling which could lead to the
wheel becoming loose and cause you to fall.
Quick-release skewer is too easy to
close
1.
Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it clockwise. This will screw
the axle in the thread. Make sure that
your wheel is correctly centred.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
A quick-release skewer is not easy
to close.
1.
Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it anticlockwise until the
quick-release axle protrudes from the axle
hole about 1 cm.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
WARNING
Reattach any previously disconnected cables (e.g. lighting cables ),
otherwise you could tear them.
3.12.3 Rims
Cleaning
1. Remove the Pedelec battery.
2. Brush the rims with a hand brush. Heavier soiling can be removed with
a soft, damp cloth.
PLEASE NOTE
Wait for the motor to cool for approximately 30 minutes after each
ride before starting cleaning.
Do not use high-pressure cleaners!
When you are cleaning the rims, make sure that no water gets into the
drive. Water ingress can damage the drive.
3. Leave to dry.
3.12.4 Tyres
DANGER
Do not either overinflate or underinflate the tyres. If the air pressure
is too high, this could lead to a worst-case scenario of the tyres
bursting and you could fall. On the other hand, if the air pressure
is constantly too low, the tyre can wear prematurely. The maximum
permissible pressure is marked on the side of the tyre in bar and psi
(pounds per square inch). You can measure the tyre pressure yourself
by using a tyre gauge. Alternatively, you can contact your cycle dealer.
