- 72 -
③
Clean the filter housing and, next, pour fuel into the filter
with the cap (D) being left installed on the new cartridge (B).
After filling the filter with fuel, remove and dispose the cap(D).
During the fitting process, spread engine oil lightly on the
surface of the cartridge's packing and install it in the filter housing.
After confirming that the packing surface contacts the seal surface,
tighten a 3/4 turn.
④
After completing the replacement with a new cartridge,
release the air out of the fuel piping system (for air releasing
method, refer to the instruction manual for the engine or
check the name plate installed on the machine.)
Get the engine started to check if there is a fuel leakage.
[Note]
Do not fail to wipe off spilled fuel completely and to ensure there is no fuel
leakage.
Parts number of fuel pre-filter cartridge :
Model name Parts number manufacture Parts number of manufactur
e
DCA-150LSK
E
Y06020 42584
KOMATSU
600-319-3610
(4)
Cleaning
of
radiator and intercooler
When
the
fin
or
tube
is
blinded,
it
should
be
cleaned
with
steam
or
high
pressure
water.
[Note]
When
a
high
pressure
washer
is
used,
spray
water
from
a
place
about
1.5m
away
to
prevent
damage
to
the
fin
or
tube.
(5)
Checking
for
terminal
and
connection
of
the
circuit.
Summary of Contents for DCA-150LSKE
