smartDEN Opener
User Manual
24 Apr 2018
- 25 -
STATUS indicator
must start blinking in 5 seconds if in Access Point network mode or will flush if
in Station network mode.
+
-
Figure 6.16.
DC jack overview
Use either only DC jack either only terminal wires at the same time for power supply.
Never use both wire and DC jack power supplies together. This may damage
smartDEN
Opener
!
smartDEN Opener
does
not accept AC supply voltage. It is highly recommended to
check the power supply source parameters before supply the module.
The power supply equipment shall be resistant to short circuit and overload in secondary
circuit.
When in use, do not place the equipment so that it is difficult to disconnect the device
from the power supply.
Installation of the board should be made by professional installers. Do not
touch/connect/disconnect peripherals while power is turned on. Always disconnect from
mains before make any changes.
+VCC
GND
(NEGATIVE)
