DAEnetIP3
User Manual
-
31
-
Figure 12.
Timer and analog input
7.5.19.
Timer and remote
In this mode the single pulse (timer) can be started by input (analog or digital)
from another DAEnetIP3 controller over the network. The user can not control
manually the outputs in this mode.
7.6.
“ON” value
This value is available for each digital output and determines the ON time (the
time when the output is in high level) when the output works in some of the pulse
modes. The ON value is >=1 and <=99.
7.7.
“OFF” value
This value is available for each digital output and determines the OFF time (the
time when the output is in low level) when the output works in some of the pulse
modes. The OFF value is >=1 and <=99.
7.8.
“Delay” value
This value is available for each digital output and determines the one shot pulse
delay time when the output works in some of the timer modes. The Delay value is
>=1 and <=99.
7.9.
“Mode” value
This value is available for each digital output and determines if the ON, OFF and
Delay values are in seconds, minutes or hours.
