Delta Compact Drive MS300 IP66/NEMA 4X Series, User Manual

Page: 124 / 135

Chapter 10 Digital Keypad

MS300 (IP66 / NEMA 4X)
10-6
<
/
<
/
<
/
<
/
The upper limit for Pr.01-00 is 599.00. If you set a value greater than 599.00, “Err” appears
after you press ENTER, and then the keypad shows the upper limit (599.00) for a second to
remind you of the incorrect setting. The setting value remains as the original set value (default
is 60.00) and the cursor returns to the last digit.
D-2. Signed Parameter Setting Status 1
(Parameter setting range can be smaller than 0; for example: Pr.03-03)
1. Without using the left shift key: use UP and LEFT/DOWN key to select and adjust the
parameters. Press ENTER after setting to the required value.
2. Using the left shift key: After you press the MODE key for >2 seconds, the last digit starts to
blink. Press the left shift key to move the blinking cursor to the digit to adjust, and increase the
value by pressing the UP key. The value goes back to 0 after 9.
3. Press LEFT/DOWN key to shift the blinking cursor one digit to the left. When you shift to the first
digit and press the UP key, the digit “0” changes to “-” (minus).
4. After you finish setting the parameter, the left shift key function is not disabled automatically until
you disable it manually.
For example: the default setting for Pr.03-03 is 0.0. Pressing the MODE key for > 2 seconds
enables the left shift function. The procedure for pressing the LEFT/DOWN key shows as
follows:
<
/
<
/
<
/
<
/
The upper limit for Pr.03-03 is 100.0 and lower limit is -100.0. If the value is more than
100.0 or less than -100.0, “Err” appears after you press ENTER, and then the keypad shows the
upper limit (100.0) or lower limit (-100.0) for a second to remind you of the incorrect setting. The
setting value remains as the original set value (0.0), and the cursor returns to the last digit.
D-3. Signed Parameter Setting Status 2
(The parameter setting range can be smaller than 0 and the lower limit should be
≦
-100.00 with two decimal places; for example: Pr.03-74)
1. Without using the left shift key: use UP and LEFT/DOWN key to select and adjust the
parameters. Press ENTER after setting to the required value.
2. Using the left shift key: After pressing the MODE key for >2 seconds, the last digit starts to blink.
Press the left shift key to move the blinking cursor to the digit to adjust, and increase the value
by pressing the UP key. The value goes back to 0 after 9.
3. Press the LEFT/DOWN key to shift the blinking cursor one digit to the left. When you shift to the
first digit and press the UP key, the digit “0” changes to “-” (minus).
4. For parameters in three digits and two decimal places with both positive and negative setting
values (Pr.03-74, -100.00 %–100.00 %), it only displays values in four digits (100.0 or -100.0).
For example: the default setting for Pr.03-74 is -100.0. If you increase the value by 0.001, it
displays -99.99.