Delta Tau Turbo PMAC Clipper, Hardware Reference Manual

Page: 77 / 84

Turbo PMAC Clipper Hardware Reference Manual
Appendix A 77
E13: Power-Up/Reset Load Source
Jumper Configuration Default
E13:
1 2

1 to 2 to reload firmware through serial or bus port

Remove jumper for normal operation
Factory
Set
E14- E17: Ports Direction Control
Jumper Configuration Default
E14:
1 2

1 to 2 to make DATx lines inputs

Remove jumper to make DATx lines outputs
Factory
Set
E15:
1 2

1 to 2 to make SELx lines inputs

Remove jumper to make SELx lines outputs
Factory
Set
E16:
1 2

1 to 2 to make MOx lines inputs

Remove jumper to make MOx lines outputs
Factory
Set
E17:
1 2

1 to 2 to make MIx lines inputs

Remove jumper to make MIx lines outputs
Factory
Set
Jumper Configuration Default
E1:
1 2 3

1 to 2 Turbo/Power/

2 to 3 for Legacy MACRO CPUs Rev. 103 or older
Factory
Set
E2:
1 2 3

1 to 2 to sample at Servo Rate

2 to 3 to sample at Phase Rate
1 – 2