Turbo PMAC Clipper Hardware Reference Manual
Troubleshooting
71
Reloading Boot and Communication Firmware
The boot and firmware .IIC files are required for this procedure. They are normally obtained directly from
Delta Tau, or downloaded from the
PMAC forum Webpage
. The following steps ensure proper
configuration:
Caution
Downloading the wrong boot or communication files will severely
corrupt the functionality of the communication processor.
Step1:
Install the E8 jumper
Step2:
Click on Store Boot
Step3:
The utility will prompt for the boot file. MAKE SURE you open the correct .IIC file (ending with
BootFx2.iic) and wait for “firmware load successful” message
Step4:
Click on Store F/W
Step5:
The utility will prompt for the Firmware file. MAKE SURE you open the correct .IIC file (ending
with ETHUSB307FX2.iic) and wait for “firmware load successful” message
Step6:
Remove the E8 jumper. Click Done, and recycle logic power (5V) on the Clipper
Summary of Contents for Turbo PMAC Clipper
