Turbo PMAC Clipper Hardware Reference Manual
Troubleshooting
69
Changing IP Address, Gateway IP, Gateway Mask
In order to change any of these addresses, install the E8 jumper prior to pressing the corresponding Store
button. The following steps ensure proper configuration:
Step1
: Change the desired address field
Step2
: Install the E8 jumper
Step3
: Press on the corresponding Store button
Store IP for changing IP address
Gateway IP for changing Gateway IP
Gateway Mask for changing Gateway
Mask
Step4
: Remove the E8 jumper after the corresponding confirmation message is received:
For changing the
IP address
, follow
through the subsequent messages for
setting up windows registry for
Pcomm32.
Gateway IP
Gateway Mask
Step5:
Click Done, and recycle logic power (5V) on the Clipper
Summary of Contents for Turbo PMAC Clipper
