Power Brick Controller User Manual
Connections and Software Setup
29
CONNECTIONS AND SOFTWARE SETUP
Warning
Installation of electrical control equipment is subject to many
regulations including national, state, local, and industry guidelines
and rules. General recommendations can be stated but it is important
that the installation be carried out in accordance with all regulations
pertaining to the installation.
AMP1
– AMP8: Output Control Signal Wiring
Connectors AMP1 – AMP8 are used to command output control signals to external amplifiers. Depending
on the option ordered, the Power Brick Controller may or may not have AMP5 – AMP8, which correspond
to Channels 5 – 8, but all models must be ordered with at least 4 axes, corresponding to Channels 1 – 4 on
AMP1 – AMP4.
True DAC/Filtered PWM Option
AMP1-AMP8: D-sub DA-15F
Mating: D-Sub DA-15M
8
7
6
5
4
3
2
1
15
14
13
12
11
10
9
Pin #
Schematic Symbol
Function
Notes
1
DACA+
Output
DAC A
2
DACB+
Output
DAC B
3
AE_NC+
Output
Amplifier Enable Relay Normally Close
4
AE_NO+
Output
Amplifier Enable Relay Normally Open
5
AFAULT- (COM)
Common
Amplifier Fault Common (Tied to AE_COM)
6
N.C.
Not connected
7
N.C.
Not connected
8
AGND
Common
Analog Ground (Tied to pin 14 internally)
9
DACA -
Output
DAC A output -
10
DACB -
Output
DAC B output -
11
AE_COM
Common
Amplifier Enable Relay Common
12
Input
Amplifier Fault +
13
N.C.
Not connected
14
AGND
Common
Analog Ground (Tied to pin 8 internally)
15
N.C.
Not connected
