122
|
Installing System Components
2
Remove all the hard drives. See "Removing a Hard-Drive Carrier” on
page 61.
3
Open the system. See "Opening the System" on page 97.
4
Disconnect all the cables from the backplane. See Figure 5-3 for 3.5-
inch hard drives and Figure 5-6 for 2.5-inch hard drives.
Note the routing of the cable underneath the tabs on the chassis as you
remove them from the system. You must route these cables properly
when you replace them to prevent the cables from being pinched or
crimped.
5
Disconnect front panel cables from the fan controller board. See Figure
5-11.
Note the routing of the cable underneath the tabs on the chassis as you
remove them from the system. You must route these cables properly
when you replace them to prevent the cables from being pinched or
crimped.
6
Remove the screws that secure the hard-drive cage to the chassis. See
Figure 3-29.
7
Remove the screws that secure the front-panel assemblies to the chassis.
See Figure 3-30.
8
Remove the hard-drive cage from the chassis. See Figure 3-30.
9
Remove the screws that secure the front-panel assembly to the hard-
drive cage. See Figure 3-36.
10
Remove the front-panel assembly from the hard-drive cage. See Figure
3-36.
