Installing System Components |
103
NOTE: To install the second power distribution board that is below the first
power distribution board, angle the board during installation.
2
Replace the screws securing the second power distribution board to the
system. See Figure 3-22.
3
Replace the power distribution board-connector. See Figure 3-22.
4
Connect all the cables to the second power distribution board. See
Figure 5-12.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
5
Replace the screws securing the first power distribution board to the
system. See Figure 3-22.
6
Connect all the cables to the first power distribution board. See Figure
5-12.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
7
Replace the power supply. See "Installing a Power Supply" on page 67.
8
Close the system. See "Closing the System" on page 98.
9
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
Fan Controller Board
Removing the Fan Controller Board
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
