Installing System Components |
131
5
Replace the hard drive cage into the chassis. See Figure 3-30.
6
Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-29.
7
Connect all the cables to the backplane. See Figure 5-6 for 2.5-inch
hard drives.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
8
Connect front panel cables to the fan controller board. See Figure 5-11.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
9
Close the system. See "Closing the System" on page 98.
10
Replace the hard drives. See "Installing a Hard Drive into a Hard-Drive
Carrier" on page 64.
11
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
