Dell POWER EDGE SC1430, Hardware Owner'S Manual

Page: 122 / 160

122
Jumpers and Connectors
Disabling a Forgotten Password
The password jumper on the system board enables the system password features or disables them and clears
any password(s) currently in use.
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 43.
3
Remove the PSWD jumper and set it aside.
See Figure 6-1 to locate the password jumper on the system board.
4
Close the system. See "Closing the System" on page 43.
5
Reconnect the system to the electrical outlet, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug
removed. However, before you assign a new system and/or setup password, you must install the jumper
plug.
NOTE:
If you assign a new system and/or setup password with the jumper plug still removed, the system
disables the new password(s) the next time it boots.
6
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
7
Open the system.
8
Reinstall the PSWD jumper.
9
Close the system, reconnect the system to the electrical outlet, and turn on the system.
10
Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Using the System Password" on
page 36.
book.book Page 122 Monday, June 5, 2006 1:51 PM