Figure 38. Removing system battery
Next step
Installing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
NOTE:
Battery is a Field Replaceable Unit (FRU). Removal and installation procedures are to be performed only by Dell certified
service technicians.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
Steps
1
Locate the battery socket. For more information, see
.
2
Hold the battery with the "+" facing up and slide it under the securing tabs.
3
Press the battery into the connector until it snaps into place.
Installing and removing system components
81
Summary of Contents for E43S Series
Page 11: ...5 iDRAC MAC address information label XC6420 Series overview 11 ...
Page 51: ...Figure 9 Removing a sled Installing and removing system components 51 ...
Page 53: ...Figure 11 Installing a sled Installing and removing system components 53 ...
Page 65: ...Figure 22 Removing an expansion card Installing and removing system components 65 ...
