Figure 12. Installing a sled blank
Next step
Follow the procedure listed in
After working inside your system
NOTE:
To add the Service Tag of the system board to match the Service Tag of the physical node, contact Dell EMC Technical
Support.
Air shroud
The air shroud aerodynamically directs the airflow across the sled. The airflow passes through all the critical parts of the sled, where the
fans push the air across the entire surface area of the heat sink. There is a vacuum created by air pulled across the hard drives, thus
allowing increased cooling.
Removing the air shroud
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
from the enclosure.
Steps
1
Press the clip on the air shroud to release the shroud from the sled.
2
Remove the shroud by rotating the shroud and releasing the hinge from the slot on the system.
54
Installing and removing system components
Summary of Contents for E43S Series
Page 11: ...5 iDRAC MAC address information label XC6420 Series overview 11 ...
Page 51: ...Figure 9 Removing a sled Installing and removing system components 51 ...
Page 53: ...Figure 11 Installing a sled Installing and removing system components 53 ...
Page 65: ...Figure 22 Removing an expansion card Installing and removing system components 65 ...
