•
#4 nut driver
•
Torx #T30 screwdriver
•
Wrist grounding strap
•
ESD mat
Inside the sled
CAUTION:
This system must be operated with the system cover installed to ensure proper cooling.
Figure 8. Inside the XC6420 sled
1
sled pull handle
2
mezzanine card
3
SATA connector
4
memory slot (4)
5
CPU1 processor heat sink module
6
CPU2 processor heat sink module socket
7
supporting bracket
8
M.2 SATA riser
9
memory slot (4)
10
PCIe expansion card riser assembly
XC6420 Series sled
The XC6420 Series sled is a server unit that is installed into the XC6400 Series enclosure. The sled features dual processors, memory, a
PCIe expansion slot, mezzanine cards, and onboard storage (SD card and M.2 SATA).
Removing a sled
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
NOTE:
The process of removing a sled blank is similar to removing a sled.
Step
Press the retaining latch and using the handle slide the sled out of the enclosure horizontally, ensuring that the sled is supported from
beneath.
50
Installing and removing system components
Summary of Contents for E43S Series
Page 11: ...5 iDRAC MAC address information label XC6420 Series overview 11 ...
Page 51: ...Figure 9 Removing a sled Installing and removing system components 51 ...
Page 53: ...Figure 11 Installing a sled Installing and removing system components 53 ...
Page 65: ...Figure 22 Removing an expansion card Installing and removing system components 65 ...