Dell Dimension L Series, Reference And Troubleshooting Manual

Page: 121 / 162

support.dell.com System Setup Program B-7
Peripheral Configuration Submenu
Figure B-4. Peripheral Configuration Submenu
Table B-5. Peripheral Configuration Submenu Options
Option Function
Serial port A Configures the serial port. Set this option to Auto (default),
Enabled , or Disabled . If set to Enabled , you can set the fol-
lowing additional options:
Base I/O O
Address
Available base I/O addresses are 3F8 , 3E8 , 2F8 , and 2E8 .
Interrupt Available interrupts are IRQ3 RQ3 and IRQ4 .
Parallel port Configures the parallel port. Set this option to Auto (default),
Enabled , or Disabled . Depending on the port setting, you
can set the following additional options:
Mode If Parallel Port is set to Auto or Enabled , available modes
are Output Only , Bi-Directional (default), ECP , and EPP .
NOTE: Refer to the device manufacturer's documentation
for information on which mode to use before changing this
before changing this
setting.
Base I/O
Address If port is set to Enabled , available base I/O addresses are
378 (default), 278 , and 228 .
Interrupt If port is set to Enabled , available interrupts are 7 and 5 .
NOTE: The Glossary in the system Help defines abbreviations and acronyms.