Dell Dimension 8400 Series, Manual

Page: 88 / 148

88
Removing and Installing Parts
www
.dell.com | support.dell.com
14
If you installed a sound card:
a
Enter system setup (see page 113), select Audio Controller , and then change the setting
to Off .
b
Connect external audio devices to the sound card’s connectors. Do not connect external
audio devices to the microphone, speaker/headphone, or line-in connectors on the back
panel.
15
If you installed an add-in network adapter and want to disable the integrated network
adapter:
a
Enter system setup (see page 113), select Network Controller, and then change the
setting to Off .
b
Connect the network cable to the add-in network adapter’s connectors. Do not connect
the network cable to the integrated connector on the back panel.
16
Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Card
1
Follow the procedures in "Before You Begin" on page 63.
2
Press the lever on the card retention arm and raise the retention arm.
3
If necessary, disconnect any cables connected to the card.
4
If your card includes a retention mechanism, remove the top of the retention mechanism by
pressing the tab and pulling up on the top.
5
Gently pull back the securing tab, grasp the card by its top corners, and then ease it out of its
connector.
6
If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell (see page 125).
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification
of the computer. The brackets also keep dust and dirt out of your computer.
7
Lower the retention arm and press it into place, securing the card(s) in the computer.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into
the computer.
8
Close the computer cover, reconnect the computer and devices to electrical outlets, and then
turn them on.
9
Remove the card’s driver from the operating system.